Question : Problem: How to Telnet into Dell 3448 Switch??

Hi. I am not very familiar w/ Telnet. Used it once or twice, but thats it. I have just bought a switch off of Ebay and I need to configure it. I have hit the reset button a few times so I should be able to get into it, but I think my issue is my lack of Telnet skills. Can someone provide help? Using a Cisco serial/RJ45 cable to the console port on the back of the switch. Any help is greatly appreciated!

Answer : Problem: How to Telnet into Dell 3448 Switch??

To telnet into the switch you need to know its IP address.  Assuming the switch was reset to factory defaults by the seller, it should not have any  IP addresses.

So you need to get a serial cable into the console port and this should let you console into the device.   Normally you can use HyperTerm with  serial settings of 9600 bps, 8-bit, no parity.