Question : Problem: BERT Controller Test

We're running a DS1 circuit from a T1 controller card on a 7206.  Back in initial testing, someone ran a BERT test for no apparent reason and now when we do a show controller t1 5/0 the BERT information is always there.  We've tried going into config mode, negating the command in various forms but it still shows up when we do the sh controller.  Heres what it looks like:

T1 5/0 is down.
  Applique type is Channelized T1
  Cablelength is long gain36 0db
   DSX1 BERT pattern     : zeros
   DSX1 BERT sync        : done
   DSX1 BERT sync count  : 0
   DSX1 BERT interval    : 1
   DSX1 BERT time remain : 0
   DSX1 BERT total errs  : 15360
   DSX1 BERT total k bits: 1093140
   DSX1 BERT errors (last): 0
   DSX1 BERT k bits (last): 0
  Receiver has remote alarm.
  alarm-trigger is not set
  Framing is ESF, FDL is ansi, Line Code is B8ZS, Clock Source is Line.

Since this circuit isn't operating, meaning it wont come up but has link lights we're trying to rule out possibilities.  Is there any way to get this BERT data off of here, or are we actually running the BERT test right now?  To show you what we're attempting, we would assume a normal read-out would look something similar to this:

T1 5/1 is up.
  Applique type is Channelized T1
  Cablelength is long gain36 0db
  No alarms detected.
  alarm-trigger is not set
  Framing is ESF, FDL is ansi, Line Code is B8ZS, Clock Source is Line.

Who knows?

Answer : Problem: BERT Controller Test

Well, there's no apparent configuration entry that would cause it.
I know this is a production router, but 7200's are a little finicky sometimes and perhaps a reboot will clear the entries.