|
|
Question : Problem: NO VIDEO SIGNAL!
|
|
NO VIDEO SIGNAL! 1. Just Built my first computer using X6DA8-G2 motherboard with Duel Xeon Processors 2. Installed an ATI Radeon 7000 64MB DDR PCI card PCI on the motherboard is 32 bit with Gaphic support 3. NO VIDEO SIGNAL AND NO ERROR CODE SOUNDS! 4. Removed Ram, got Error Code for Ram. 5. Restalled the Ram, no error code. 6. Removed Video Card got Video Card error Code. 7. Reinstalled Video Card, No Error Code. 8. Tried connecting to DVI than to15 Pin D sub 9. Bought a Nother ATI Radeon 7000, assume the first one was bad Video Card. 10. HAD THE SAME RESULTS - NO VIDEO SIGNAL! 11. Went to ATI website Found Artical on Radeon 7000 is not compatible for some motherboards? 12. Bought a Radeon 9250 256MB DDR PCI. 13. NO VIDEO SIGNAL! 14. Checked the cable Pins they are good. 15. Try my 64 bit bus slots (3) NO VIDEO SIGNAL AGAIN!! Question: WHAT IS NEXT??
Dan from Chicago, IL
|
Answer : Problem: NO VIDEO SIGNAL!
|
|
Actually, this sounds like a typical DVI problem. if you've been reading the boards, DVI has this problem alot. There are some solutions:
1. Make sure that you have selected Digital input on your monitor's selector - as flat panels have pushbutton to select between analog/digital/svideo etc... 2. If it is a Dell monitor, you may need flash update to the monitor's digital program - you have to call Dell Tech support for that, though. 3. The video card may have a setting to send it to the proper signal (DVI in this case) go to the settings for the digital card and make sure that it is outputting to the digital interface.
hope this helps!
Jim
|
|
|
|