Question : Problem: Bonded T1 Access for Cisco 7206

We're trying to figure out if this can work, and if so, how to do it:

We'd like to run two DS1 circuits to an A-location where there would be a 2600 series Cisco router.  Then, for our Z-location, we would like the DS1s to appear back at our Cisco 7206 router.  The cisco router has some fast ethernet ports, some DS3 ports and a single card with 8 Ethernet ports on it.  We're trying to know if we can plug in those two DS1 connections into two of the Ethernet jacks, establish point-to-point WAN connections to each interface on the 2600 and then somehow bond the two circuits to form a 'bonded 3Mb T1."

I know you guys can figure this one for me... we're trying to figure it out urgently so its been marked for 500 points.

Answer : Problem: Bonded T1 Access for Cisco 7206

According to the Cisco site, the feature was introduced in 12.0(19)S.  You should be good to go with 12.2T.