Microsoft
Software
Hardware
Network
Question : Problem: Trying to connect Netgear FVS318 to Linksys AM200 DSL modem
Hi - I'm trying connect a Netgear FVS318 VPN Firewall router to a Linksys AM200 ethernet modem.
I want the Netgear for port redirection for VPN and Terminal Services and to act as a hardware firewall. I used this many things but can't get hold of the modem I normally use and the Linksys is very different.
I can access the Internet through the modem only which has a single ethernet port but as soon as I link the Netgear it runs through it's setup, detects the connection type as a fixed IP, asks you to input network IP details, DNS servers, etc and continues through the setup until it tells you it cannot connect to the Internet.
Linksys have checked my settings and everything is correct so I wonder where I am going wrong on the Netgear.
Any ideas??
Thanks,
Mike
Answer : Problem: Trying to connect Netgear FVS318 to Linksys AM200 DSL modem
Sorted with help from Linksys, Netgear were hopeless.
Random Solutions
Problem: Printer "Cannot install this Hardware" message
Problem: where can i get a replacement mother board?
Problem: WTF's up with my iSCSI network config ???
Problem: SigmaTel High Definition Audio in Sony Vaio can't start
Problem: When installed firmware, can you load preconfigured WM5 settings to the terminal.
Problem: Hot-swap eSATA drives
Problem: BES software download timeout
Problem: Can't see hard drive.
Problem: Cisco 837 NAT Acess-lists and VPN
Problem: Fiber connection between Cisco and Netgear