Microsoft
Software
Hardware
Network
Question : Problem: Entering server in safe mode
Hi
I have a Proliant DL380 G5 that I want to boot into safe mode, but whenever I press F8 it goes either into the iLO config or the OS boots up normally.
Can someone confirm what button I have to press and when?
Answer : Problem: Entering server in safe mode
The answer to your question is that You need to press F8 just after the F10 prompt and just as the Operating System starts to boot...
Random Solutions
Problem: Using a packet sniffer utility to determine if a network card is bad
Problem: DLT Drive not recognizing cleaning tape
Problem: JetDirect 175x not being assigned an IP address
Problem: How to enable SFTP logging?
Problem: NO SOUND AT REAR AUDIO PLUG
Problem: PPP Multilink on Cisco 1841
Problem: QOS for voice traffic
Problem: Use VNC to broadcast Single Application / Window
Problem: Nortel 4528 VLAN internet access
Problem: Handhead will not display the content in folders