Question : Problem: Router stuck at rommon

Ok, I tried to load a new IOS and I didnt have enough room. Now when my router boots, it gives a crapload of errors and is at the ROMMON prompt.  This is a 2600 series router. I tried the copy xmodem: stuff but it didnt work.

How do I erase the flash? Then install a new IOS (I'm assuming I have to use xmodem since it cant even boot into the IOS)?
Thank you

Answer : Problem: Router stuck at rommon

You can configure an ethernet ip address and use tftp from the rommon prompt.

Here's the step-by-step:
How to Download a Software Image to a Cisco 2600 via TFTP Using the tftpdnld ROMMON Command
http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bf9e.shtml

Hope this helps :)